Notes about this build:

• Look through the pages for each build. You will build 2 to 3 of the same flowers at times. For each flower, read through the pages. If you are building the flowers individually, then the last page for that flower will not show and #X (i.e. 3X three of the same flower part), but in some cases, the last page of that flower will then say "3X" meaning you will have to go back and build two more exactally the same as how you built this last one. But in some cases, you will not see anything like this. What that means is the next page will start over again (might be something different on that flower). This will keep you on your toes. 
• Be gentle when working with the part Plant, w/ 3.2 shaft, No. 1 (see below). It is very easy to break off the arms of these pieces. 

• Make sure you are building this kit on a good non-shag carpet with a neutral color, as there are a lot of small parts that may fall. I spent a lot of time picking up pieces I kept dropping. 
• Get yourself a vase to place the flowers in when you are done. 

• On page #65, make note that you will create two three-level flowers, one two-level flowers, and one one-level flower. You will also notice that you clip these on to the piece you created on page #64. 

Breakdown

Breakdown was fast and easy. Here are some quick notes about breaking down this kit:

• Use hook needle to remove PLATE 1X2, W/ 1 KNOB found on page #71. 
• Use the hook needle To seperate FINAL BRICK 2X2 from PLATE 2X2,2/3 W/KRYDSHUL& CROWN LEAF. You will push the hook needle through the plate crown leaf pushing the Final brick out. 
• I would suggest using a seperate bag to store the CROSS AXLE 32M which are used as the stems. There is a chance that the bag may rip and you don't want all your parts falling out if this should happen. 
• Seperating the center leafs (white) from the middle of this flower (page 21 is a little tricky). I suggest you use your hook needle to first wedge out the FLOWER 1X1. Now you can place your hook needle into the BRICK 1X1 W. 4 KNOBS, and gently wiggle the hook needle until this piece comes out. 
• When you get to the PLATE 2X2 W 1 KNOB on page 22, move on to page 21. You find it eaiser to seperate the plate after you pull apart the pieces on page 21.