Notes about this build:

• Fun build. You will get two bags, but breakdown will go into one Ziplock. 
• You will build two of (Almost) the same part until you get to the stems. One will be angled, one will be straight.

Breakdown Notes:

• Very simple breakdown and only takes around 12 mins. Start at the back of the book and work backwards until yout get to page 8.
• At page 17, remove the two HORN 2,5M Ø3,2 WITH SHAFT from the two ANGLE ELEMENT, 157,5 DEGR. [3]. 

• At page 16, don't forget to seperate the two green PL.ROUND 1X1 W. THROUGHG. HOLE from the two ANGLE ELEMENT, 157,5 DEGR. [3]. 

• On page 13 remember that you will mulitply the number of each part by 2 as you will be breaking down both flowers

• On pages 12 & 9, remember to seperate the red PLATE 1X2 W. 1 HORIZONTAL SNAP from the red PLATE W. BOW 3X4X2/3 W. KNOBS (remember, you are working backwards. 

• For pages 3 thru 8, it is my easier if you follow these instructions. 
• Start at page 4. You will pull the pieces BRICK Ø16 W. CROSS away from ANGULAR PLATE 1.5 BOT. 1X2 2/2

• Seperate the BRICK Ø16 W. CROSS from the green STEERING WHEEL NO. 1 using the Brick Separator. 

• Seperate the light green PLATE 2X2 ROUND from the STEERING WHEEL NO. 1 using the Pick Hook tool (Brick Seperator is hard to use on this. 

• Page 5 thru 6, pull the BRICK Ø16 W. CROSS away from the other set ot BRICK Ø16 W. CROSS. Now pull the PLATE W. BOWS 2X1½ from the BRICK Ø16 W. CROSS. 

• Page 7, you can now pull the black PLATE 2X2 W 1 KNOB

• You can now breakdown page 8. Pull the PLATE 1X1 W/TOOTH (4 of them) from the BRICK 1X1 W. 4 KNOBS. 

• And finally don't forget to pull the FLOWER 1X1 from the top of the BRICK 1X1 W. 4 KNOBS.